ProSun T-Max G2 Access Point Wireless Adapter

The T-Max G2 Access Point Wireless Adapters allow you to control your salon without the need to run cables throughout your salon.

The G2™ Wireless modules use a 900MHz RF signal to communicate without the need to run cables. These G2 Wireless adapters can reach up to 300 feet.

Wireless Set Up Configuration: 

The G2™ Access Point will connect to any T-Max® Timer that is wireless ready.

Simply connect a G2™ Access Point to a control unit such as either the T-Max Manager G2 Control Unit or the T-Max 3W G2 Timer at your front desk and then connect a second G2™ Access Point to each tanning bed timer.

With this configuration you'll no longer need to run RJ22 cables throughout your salon and the units can operate wirelessly. 

Purchase Includes:

• 1 - T-Max G2 Access Point Wireless Adapter Note: one Access Point is needed per bed or booth and then one Access Point will need to be attached to the T-Max Control Manager or Timer at the front desk.
  
• 1 - 15 Feet of RJ11 to RJ11 6 Conductor Cable (Connects Wireless Adapter to RJ11 port on the Bed/Booth)

Best Practice: To maximize reception in buildings with structures that may block wireless reception the adapters are often all positioned above the drop ceiling so line of site can be obtained from the adapter at the bed/booth to the adapter connected to the Control Manager at the front desk.  

Warranty:

• 2 Year Manufacturer Warranty.

Operation Manual / Technical Specifications