How to Use Spray Tan Foot Protectors for Clean Results

Quick Answer

Apply spray tan foot protectors before the final mist to keep soles clean and avoid client embarrassment. Use the light adhesive side down for residue-free removal.

Step-by-Step Guide to Using Spray Tan Foot Protectors

1. Prep the Feet: Ensure the client's feet are clean, dry, and free of lotion or barrier cream. Any residue can prevent the protector from sticking. Skipping this step may cause the protector to lift during spraying.
2. Apply the Protector Before the Final Mist: After the client has been sprayed with the first coat (excluding the feet), peel one protector from the liner and press the light adhesive side onto the sole of each foot. Smooth out any air bubbles. Applying too early can trap tan solution under the protector; applying too late may already stain the sole.
3. Spray Over the Feet Normally: Continue spraying the tan solution over the tops of the feet and toes as usual. The protector will block overspray from reaching the sole. Do not spray directly onto the protector's edge—angle the gun slightly to avoid lifting it.
4. Remove After the Session: Gently peel the protector off each foot immediately after the spray session ends. The light adhesive should release without pulling skin or leaving residue. If the protector feels stuck, do not yank—dab a little water on the edge to loosen it.
5. Dispose and Sanitize: Discard the used protectors after a single use. Wipe the client's feet with a clean towel to remove any excess powder or adhesive. Never reuse protectors—they are single-use disposable items for hygiene reasons.

Product Facts

• Spray Tan Feet Foot Protectors Pink 100 Each/50 Pairs: Spray Tan Feet Foot Protectors Pink 100 Each/50 Pairs – light pink, light adhesive, residue-free removal. The light adhesive holds the protector in place during application but peels off cleanly, so you don't have to scrub sticky residue off clients' feet.