How to Set Up a Buck Booster for Your Tanning Bed
By Spray & Sun | Published: 2026-10-18
Category: How-to Guides
Learn how to install a buck booster for your tanning bed to stabilize voltage and ensure consistent lamp output. Step-by-step guide with common mistakes to avoid.
Quick answer
To set up a buck booster for your tanning bed, first verify your incoming voltage and your bed's requirements, then connect the booster according to the manufacturer's wiring diagram, and finally test the output before use.
Why voltage stability matters
Tanning beds rely on consistent voltage to keep lamps burning evenly. Fluctuations can cause flickering, uneven tanning, and premature lamp failure. A buck booster helps stabilize and boost voltage, ensuring your ProSun bed operates efficiently and lamps last longer.
Before you start, confirm which type of booster you need. The ProSun Buck Booster 0.50 KVA is designed for smaller beds, while the Buck Booster 1.0 KVA suits larger units. Choosing the wrong size can lead to inadequate correction or overloading.
Step-by-step installation
- Check incoming voltage: Use a multimeter to measure the voltage at the outlet where you'll plug in the tanning bed. Record the reading; you'll need this to determine if a buck or boost is required. If the reading is outside the bed's rated range, a booster is necessary.
- Select the correct booster size: Match the booster's KVA rating to your bed's power draw. For most home ProSun beds, the 0.50 KVA works; for larger commercial units, choose the 1.0 KVA. Check your bed's manual for the exact requirement. Oversizing is safer than undersizing, but verify compatibility.
- Turn off power and connect wires: Switch off the circuit breaker before wiring. Connect the booster's input wires to the incoming power and the output wires to the tanning bed, following the wiring diagram included with the booster. Use wire nuts and secure all connections. Double-check that all connections are tight and no bare wires are exposed.
- Test the output voltage: After wiring, turn the breaker back on and measure the output voltage at the bed's connection point. It should be within the bed's specified range (e.g., 110V for a 110V bed). If not, recheck your wiring. Never operate the bed if the voltage is still incorrect; seek professional help.
Products that help
- ProSun Buck Booster 0.50 Kva: The ProSun Buck Booster 0.50 KVA is designed to stabilize and boost voltage for ProSun tanning beds, ensuring consistent lamp output and efficient operation. This helps maintain even tanning results and extends lamp life, making it a reliable choice for smaller ProSun models.
ProSun Buck Booster 0.50 Kva - Buck Booster 1.0 Kva: The Buck Booster 1.0 KVA adds protective coverage to your purchase and is compatible with eligible orders from Spray & Sun. It provides peace of mind and safeguards your equipment, which is useful if you're installing a booster on a larger bed.
Buck Booster 1.0 Kva
