How to Install a Buck Booster for Your Tanning Bed

By Spray & Sun | Published: 2026-10-19

Category: How-to Guides

Learn how to install a buck booster for your tanning bed. Follow these step-by-step instructions for safe voltage regulation and setup.

Quick Answer

Installing a buck booster for your tanning bed involves connecting the device between your power source and the bed to regulate voltage. Follow the steps below for a safe setup.

Why You Might Need a Buck Booster

Tanning beds often require specific voltage levels to operate efficiently. If your home or salon has voltage fluctuations or the bed is designed for a different standard (e.g., 220V vs 110V), a buck booster helps maintain consistent voltage. The Buck Booster 0.75 Kva from Spray & Sun is a straightforward solution for light commercial or household use, but it is not a universal fix for all electrical issues.

Safety First: Know Your Electrical Setup

Before starting, confirm your tanning bed's voltage requirements and your outlet's output. If you are unsure about electrical work, consult a licensed electrician. The Buck Booster 0.75 Kva supports a rated capacity of 0.75 Kva, which is suitable for many tanning beds, but check your bed's power draw to avoid overloading.

Step-by-Step Installation Guide

Turn Off Power and Unplug the Tanning Bed: Switch off the circuit breaker for the outlet you will use, and unplug the tanning bed. Verify power is off with a voltage tester. Never work on live circuits; double-check with a tester.
Mount the Buck Booster Securely: Place the Buck Booster 0.75 Kva on a flat, dry surface near the outlet and tanning bed. Use the mounting holes if provided, or set it on a non-conductive shelf. Ensure ventilation around the unit. Avoid placing it in damp or enclosed spaces to prevent overheating.
Connect Input Wires to Power Source: Identify the input terminals on the buck booster (usually marked LINE or INPUT). Connect the hot (black) and neutral (white) wires from your power source to these terminals, following the manufacturer's wiring diagram. Secure with wire nuts. Common mistake: reversing hot and neutral can damage the booster or bed.
Connect Output Wires to Tanning Bed: From the output terminals (marked LOAD or OUTPUT), run wires to the tanning bed's power cord or hardwired connection. Match polarity (hot to hot, neutral to neutral). Use appropriate gauge wire for the load. Ensure the tanning bed is unplugged during this step to avoid accidental startup.
Ground the System: Connect the ground wire (green or bare copper) from the power source to the ground terminal on the buck booster, then to the tanning bed's ground. This protects against electrical shock. Skipping the ground is a safety hazard and may void warranties.
Test Before Full Use: Restore power at the breaker, plug in the tanning bed, and turn it on briefly. Use a multimeter to check the output voltage at the bed's connection point. It should match the bed's rated voltage (e.g., 110V or 220V). If voltage is incorrect, recheck wiring immediately and consult a professional.

Product Spotlight

Buck Booster 0.75 Kva: Rated capacity of 0.75 Kva, helps maintain consistent voltage levels. This ensures your tanning bed receives stable power, reducing the risk of damage from voltage spikes or drops.
Buck Booster 0.75 Kva