What This Kit Includes
The ProSun Luxura X7 10 Minute Full Hybrid Red Light Lamp Conversion Kit is designed to upgrade an existing ProSun Luxura X7 10 Minute tanning bed. It includes 24 RenuvaTan Intensive 200W Red Light Tanning Lamps for the canopy, 18 RenuvaTan Intensive 200W XL Red Light Tanning Lamps for the bench, and 4 RedSun Facial 400-500W Lamps for the facial area. This combination delivers both traditional UV tanning and red light therapy (RLT) in a single session.
Kit Contents at a Glance
- ProSun Luxura X7 10 Minute Full Hybrid Red Light Lamp Conversion Kit: 24 x RenuvaTan Intensive 200W Red Light Tanning Lamps (Canopy) These canopy lamps provide the primary UV and red light output for upper body sessions.

ProSun Luxura X7 10 Minute Full Hybrid Red Light Lamp Conversion Kit - ProSun Luxura X7 10 Minute Full Hybrid Red Light Lamp Conversion Kit: 18 x RenuvaTan Intensive 200W XL Red Light Tanning Lamps (Bench) The bench lamps are longer to cover the lower body area evenly.
- ProSun Luxura X7 10 Minute Full Hybrid Red Light Lamp Conversion Kit: 4 x RedSun Facial 400-500W Lamps (Facial) Higher wattage facial lamps target the face and décolletage for a more balanced tan.
Installation Checkpoints
Before starting, confirm that your tanning bed is a ProSun Luxura X7 10 Minute model. This kit is a certified compatible replacement lamp kit for that specific unit. The lamps use Bi-Pin connectors, so check your existing lamp type before ordering.
- 1. Turn off and unplug the bed: Safety first. Disconnect the bed from power and allow it to cool completely before handling any lamps.
- 2. Remove old lamps: Carefully remove the existing lamps from the canopy, bench, and facial sections. Dispose of them properly according to local regulations.
- 3. Install new canopy lamps: Insert the 24 RenuvaTan Intensive 200W lamps into the canopy sockets. Ensure each lamp is securely seated in its Bi-Pin holder.
- 4. Install new bench lamps: Insert the 18 RenuvaTan Intensive 200W XL lamps into the bench sockets. These are longer, so verify the alignment with the fixture.
- 5. Install facial lamps: Insert the 4 RedSun Facial 400-500W lamps into the facial area. These higher-wattage lamps require careful handling due to their size.
- 6. Test the setup: Reconnect power and turn on the bed briefly to confirm all lamps illuminate. If any lamp does not light, double-check the connection or replace it.
What the Supplied Information Does Not Cover
The catalog does not include specific wiring diagrams, timer adjustments, or acrylic removal instructions. If your bed requires disassembly beyond lamp replacement, consult the original manufacturer manual or a qualified technician. The kit is rated for 1000 hours of life and is compatible with both home and commercial use, but installation procedures may vary slightly between individual units.


