MineTan Tan.Wave Portable Extraction Unit: Setup and Use
By Spray & Sun | Published: 2026-11-01
Category: How-to Guides
Set up the MineTan Tan.Wave portable extraction unit correctly for mobile or salon spray tanning. Step-by-step guidance on placement, airflow, and safe operation.
Quick answer
Place the Tan.Wave unit on a stable surface near your spray tanning area, connect the extraction hose, and turn it on before you start spraying. Keep the unit running for a few minutes after you finish to clear lingering overspray.
Why placement and airflow matter more than power alone
The Tan.Wave uses Micro-Whirlwind Technology to pull overspray out of the air, but its effectiveness depends on where you put it. Position the unit so the extraction inlet is close to the spray path—ideally within a few feet of where you’ll be spraying—and ensure there’s a clear path for air to enter the room. Avoid blocking the unit’s vents or placing it behind furniture.
For mobile tanners, the unit’s lightweight design and handle make it easy to carry, but you still need to check that the room has adequate ventilation. If you’re in a small space, run the extractor on high for a few minutes before spraying to establish airflow.
When a portable extractor is the right choice
The Tan.Wave is designed for mobile tanners, small salons, or home use where a permanent booth isn’t practical. It’s powerful enough to extract overspray in any room, but it’s not a substitute for a full spray tan booth with integrated ventilation. If you regularly spray in a dedicated room, a booth system may offer better containment. For occasional or on-the-go use, the Tan.Wave’s portability is a clear advantage.
Step-by-step setup and use
- Position the unit: Place the Tan.Wave on a flat, stable surface near your spray tanning area, with the extraction inlet facing the spray zone. Keep at least a few inches of clearance around the unit for airflow. Common mistake: placing the unit too far from the spray path reduces capture efficiency.
- Connect the extraction hose: Attach the flexible hose to the unit’s inlet and position the other end where overspray is heaviest—typically at waist height near the client. Ensure the hose is not kinked or blocked. Checkpoint: a kinked hose will cut airflow dramatically; straighten it before turning on.
- Power on before spraying: Turn on the Tan.Wave and let it run for a minute to establish airflow. Then begin your spray tanning session. Common mistake: starting to spray before the extractor is running leaves overspray in the air.
- Adjust airflow as needed: If you notice overspray lingering, move the hose closer to the spray source or increase the unit’s fan speed if adjustable. For larger rooms, you may need to reposition the unit mid-session. Checkpoint: always keep the hose inlet within the spray plume for best results.
- Run after spraying: Keep the extractor running for 3–5 minutes after you finish spraying to clear any remaining overspray from the air. Common mistake: turning off immediately traps residual mist that can settle on surfaces.
- Clean and store: Wipe down the exterior and check the hose for solution buildup. Store the unit in a dry place; the handle makes it easy to hang or carry. Checkpoint: regular cleaning prevents clogging and maintains extraction power.
Product facts
- MineTan Tan.Wave Portable Extraction Unit: Portable extraction and ventilation system using Micro-Whirlwind Technology. This technology is designed to capture overspray efficiently, making it suitable for mobile tanners who need reliable extraction in various locations.
MineTan Tan.Wave Portable Extraction Unit - MineTan Tan.Wave Portable Extraction Unit: Lightweight unit includes a handle for easy transport. You can move it between clients and rooms without strain, which is essential for mobile spray tanning businesses.
